Steps
1. Align and place the touchpad module into the slot on the palmrest assembly.
2. Install the two (M2x2) screws to secure the touchpad module to the palmrest assembly.
3. Align and place the touchpad bracket on the touchpad module.
4. Install the three (M2x2) screws to secure the touchpad bracket to the touchpad module.
5. Connect the touchpad cable to the connector on the system board and close the latch.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the microSD-card.
4. Follow the procedure in after working inside your computer.
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Enter the service mode.
4. Remove the base cover.
5. Remove the display assembly.
6. Remove the input output board.
7. Remove the heatsink assembly.
About this task
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
48
Removing and installing components
To Next Page
Loading...
