Steps
1. Align and place the system chassis under the hinges of the display assembly.
2. Install the (M2x2.5) screw and four (M2x3) screws that secure the display hinges to the system.
3. Connect the display cable to its connector on the system board. Adhere the adhesive tape to secure the display cable.
4. Align and place the display cable bracket in place.
5. Install the (M2x2.5) screw to secure the display cable bracket.
Next steps
1. Install the base cover.
2. Exit the service mode.
3. Install the microSD-card.
4. Follow the procedure in after working inside your computer.
Input Output board
Removing the Input Output board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Enter the service mode.
4. Remove the base cover.
About this task
The following image indicates the location of the Input Output board and provides a visual representation of the removal
procedure.
42
Removing and installing components
To Next Page
Loading...
