3. Enter the service mode.
4. Remove the base cover.
About this task
The following image indicates the location of the battery and provide a visual representation of the removal procedure.
Steps
1. Peel the adhesive tapes that secure the battery in place.
2. Peel the adhesive tape and disconnect the battery cable from the connector on the battery.
3. Peel the adhesive tapes and unroute the battery cable from the routing channel in the battery.
4. Remove the three (M2x3) screws that secure the battery to the palmrest assembly.
5. Carefully lift and remove the battery from the chassis.
Installing the 3-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
30
Removing and installing components
To Next Page
Loading...
