Steps
1. Align and place the power-button board on the chassis.
2. Install the (M2x3) screw to secure the power-button board to the chassis.
3. Connect the power-button board cable to the connector on the system board and close its latch.
Next steps
1. Install the heatsink assembly.
2. Install the input output board.
3. Install the display assembly.
4. Install the base cover.
5. Exit the service mode.
6. Install the microSD-card.
7. Follow the procedure in after working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Enter the service mode.
4. Remove the base cover.
5. Remove the speaker.
6. Remove the M.2 solid-state drive.
7. Remove the system fan.
8. Remove the display assembly.
9. Remove the input output board.
50
Removing and installing components
To Next Page
Loading...
