Steps
1. Align and place the Input Output board on the palmrest assembly.
2. Install the (M2x2.5) screw to secure the Input Output board to the palmrest assembly.
3. Connect the Input Output board cable to the connector on the Input Output board and close its latch.
4. Gently press the left hinge in downward direction toward the system.
5. Install the two (M2x3) screws to secure the left display hinge to the system.
Next steps
1. Install the base cover.
2. Exit the service mode.
3. Install the microSD-card.
4. Follow the procedure in after working inside your computer.
Heatsink assembly
Removing the heatsink assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Enter the service mode.
4. Remove the base cover.
44
Removing and installing components
To Next Page
Loading...
