Steps
1. Align and place the type-c bracket on the system board.
NOTE:
The type-c bracket must be installed on the system board before installing the system board into the palmrest
assembly. Technicians cannot install the Type-c bracket once the system board is assembled into the palmrest assembly.
2. Align and place the system board on the chassis.
3. Install the (M2x3) screw to secure the type-c bracket in place.
4. Install the (M2x2.5) screw to secure the system board in place.
5. Connect the input output board cable to the connector on the system board and close the latch.
6. Connect the power cable, power button with finger print reader cable, speaker cable, and coin-cell battery cable to the
connectors on the system board.
7. Connect the touchpad cable, keyboard cable, and LED cable to the connectors on the system board and close the latch.
Next steps
1. Install the power button with fingerprint reader.
2. Install the heatsink assembly.
3. Install the input output board.
4. Install the display assembly.
5. Install the system fan.
6. Install the M.2 solid-state drive.
7. Install the speakers.
8. Install the base cover.
9. Exit the service mode.
10. Install the microSD-card.
11. Follow the procedure in after working inside your computer.
Removing and installing components
55
To Next Page
Loading...
