Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the battery and provide a visual representation of the removal procedure.
Figure 15. Removing the battery
Steps
1. Disconnect the battery cable from the connector on the system board (if not disconnected earlier).
2. Remove the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
3. Lift the battery off the palm-rest and keyboard assembly.
Installing the battery
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the battery and provide a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
43
To Next Page
Loading...
