3. Remove the antenna cables from the routing guides on the palm-rest and keyboard assembly.
4. Turn the computer over and open the display at an angle of 90 degrees.
5. Rotate the computer and place it in a position that allows access to the screws on the display.
6. Remove the six screws (M2.5x3.8) that secure the left and right display hinges to the palm-rest assembly.
7. Carefully lift the display assembly from the palm-rest assembly.
8. Carefully place the display assembly on a clean, flat surface.
Installing the display assembly
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation
procedure.
Figure 25. Installing the display assembly
Removing and installing Field Replaceable Units (FRUs)
51
To Next Page
Loading...
