Installing the display cable
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display cable and provide a visual representation of the installation procedure.
Figure 50. Installing the display cable
Steps
1. Place the display cable on the display back cover.
2. Adhere the display cable to the display back cover.
Next steps
1. Install the camera module.
2. Install the display panel.
3. Install the display hinges.
4. Install the display bezel.
5. Install the display assembly.
6. Install the wireless card.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
75
To Next Page
Loading...
