Installing the display back cover and antenna assembly
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display back cover and antenna assembly and provide a visual representation of
the installation procedure.
Figure 52. Installing the display back cover and antenna assembly
Steps
Place the display back cover and antenna assembly on a flat surface.
Next steps
1. Install the display cable.
2. Install the camera module.
3. Install the display panel.
4. Install the display hinges.
5. Install the display bezel.
6. Install the display assembly.
7. Install the wireless card.
8. Install the base cover.
9. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
77