Figure 26. Installing the display assembly
Steps
1. Align the screw holes on the palm-rest assembly with the screw holes on the display hinges.
2. Replace the six screws (M2.5x3.8) that secure the left and right display hinges to the palm-rest assembly.
3. Turn the computer over and open the display at an angle of 90 degrees.
4. Close the display and turn the computer over.
5. Connect the display cable to the system board.
6. Adhere the tape that secures the wireless antenna cable in place on the system board.
7. Route the antenna cables on the routing guides on the palm-rest and keyboard assembly.
Next steps
1. Install the wireless card.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following images indicate the location of the speakers and provide a visual representation of the removal procedure.
52
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
