Steps
After performing the pre-requisites, you are left with the palm-rest and keyboard assembly.
Installing the palm-rest and keyboard assembly
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the palm-rest and keyboard assembly.
Figure 54. Installing the palm-rest and keyboard assembly
Steps
Place the palm-rest and keyboard assembly on a flat surface and perform the post requisites to install the palm-rest and
keyboard assembly.
Next steps
1. Install the system board.
2. Install the speakers.
3. Install the display assembly.
4. Install the heat sink.
5. Install the battery.
6. Install the fan.
7. Install the wireless card.
8. Install the M.2 2230 solid-state drive.
9. Install the base cover.
Removing and installing Field Replaceable Units (FRUs)
79
To Next Page
Loading...
