Display back cover and antenna assembly
Removing the display back cover and antenna assembly
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the display assembly.
5. Remove the display bezel.
6. Remove the display hinges.
7. Remove the display panel.
8. Remove the camera module.
9. Remove the display cable.
About this task
The following images indicate the location of the display back cover and antenna assembly and provide a visual representation of
the removal procedure.
Figure 51. Removing the display back cover and antenna assembly
Steps
After performing the steps in the pre-requisites, we are left with the display back cover and antenna assembly.
NOTE:
The display back cover and antenna assembly cannot be further disassembled after performing all the steps in the
pre-requisites. If the antenna cables are malfunctioning and must be replaced, replace the entire display back cover and
antenna assembly.
76 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
