4. Adhere the coin-cell battery to the inner frame.
Next steps
1. Install the WLAN card.
2. Install the WWAN card.
3. Install the 2280 SATA SSD.
4. Install the battery.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Hard disk drive
Removing the Hard drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The figure indicates the location of the HDD and provides a visual representation of the removal procedure.
Steps
1. Locate the HDD on your computer.
2. Disconnect the HDD cable from the system board.
3. Remove the four (M2x2.7) screws that secure the HDD to the system board.
4. Remove the HDD from the computer.
Disassembly and reassembly
29
To Next Page
Loading...
