4. Align and place the heatsink assembly into the slot.
5. Replace the seven (M2x3) screws to secure the heatsink assembly to the system board.
6. Connect the heatsink fan cable to the connector on the system board.
Next steps
1. Install the inner frame
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
DC-in port
Removing the DC-in
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the heatsink-discrete.
About this task
The figure indicates the location of the DC-in and provides a visual representation of the removal procedure.
Disassembly and reassembly
37
To Next Page
Loading...
