Steps
1. Insert the camera into the slot on the display back cover .
2. Connect the camera cable to the connector and adhere the adhesive tape above the camera connector.
3. Affix the two conductive tape above the camera module.
Next steps
1. Install the display panel.
2. Install the display hinge caps.
3. Install the display bezel.
4. Install the display assembly.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Palmrest assembly
Replacing the palmrest assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the 2280 SATA SSD.
5. Remove the memory.
6. Remove the WLAN card.
7. Remove the WWAN card.
8. Remove the inner frame.
9. Remove the LED board.
10. Remove the DC-in.
11. Remove the system board.
NOTE: System board can be removed with heatsink attached.
Disassembly and reassembly 83
To Next Page
Loading...
