Installing the Smart Card
1. Replace the Smart Card Reader in the computer in its original position.
2. Tighten the screws of the Smart Card Reader.
3. Connect the Smart Card Reader cable on the system board.
4. Install the
Palmrest Assembly
.
5. Install the
Keyboard
.
6. Install the
Keyboard Trim
.
7. Install the
Hard Drive
.
8. Install the
Base Cover
.
9. Install the
SD Card
.
10. Install the
Battery
.
11. Install the
ATG Port Cover
(only for E6420 ATG systems).
12. Install the
ATG Handle
(only for E6420 ATG systems).
13. Follow the procedures in
After Working Inside Your Computer
.
71
To Next Page
Loading...
