Cable holder
Removing cable holder
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a stand
b optical drive
c back cover
d system board shield
e graphics card assembly
3 To remove cable holder:
a Disconnect and unroute VGA and SATA ODD cables from the system board [1]
b Remove the M2x2.5 screws that secure VGA and SATA ODD cables on the computer [2].
c Lift the cable holder away from the computer [3].
Installing cable holder
1 Route the VGA and SATA ODD cable the slot on the chassis.
2 Replace the M2x2.5 screws to secure the VGA and SATA ODD cable on the computer.
3 Connect the VGA and SATA ODD cables to the connector on the system board.
4 Install the:
a graphics card assembly
b system board shield
c back cover
d optical drive
Removing and installing components
15
To Next Page
Loading...
