Dell OptiPlex 3050 - Removing System Fan (65 W); Installing System Fan (65 W)

3 Connect the system fan cable to the connector on the system board.
4 Install the:
a system board shield
b back cover
c optical drive
d stand
5 Follow the procedure in After working inside your computer.
Removing system fan (65 W)
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a stand
b optical drive
c back cover
d system board shield
3 To remove system fan:
a Disconnect the system fan cable [1].
b Remove the M3.5x5 screws that secure the system fan to the system board [2].
c Lift the system fan away from the computer [3].
Installing system fan (65 W)
1 Place the system fan to align with the screw holders on the chassis.
2 Replace the M3.5x5 screws to secure the system fan to the chassis.
3 Connect the system fan cable to the connector on the system board.
4 Install the:
22
Removing and installing components