e stand
5 Follow the procedure in After working inside your computer.
Memory module
Removing memory module
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a stand
b optical drive
c back cover
d system board shield
3 To remove memory module:
a Pry the retention clips away from the memory module until it pops-up [1].
b Lift the memory module from the connector [2].
4 Perform the same steps to remove the second memory module.
Installing memory module
1 Insert the memory module into the slot and press until the clips snap-in.
2 Perform the same steps to insert the second memory module.
3 Install the:
a system board shield
b back cover
c optical drive
d stand
16
Removing and installing components
To Next Page
Loading...
