EasyManuals Logo

Dell PowerConnect 7024 User Manual

Dell PowerConnect 7024
1234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #971 background imageLoading...
Page #971 background image
Configuring OSPF and OSPFv3 971
Configuring OSPF Interface Settings
Beginning in Privileged EXEC mode, use the following commands to
configure per-interface OSPF settings.
passive-interface default Configure OSPF interfaces as passive by default.
This command overrides any interface-level passive mode
settings.OSPF does not form adjacencies on passive
interfaces but does advertise attached networks as stub
networks.
timers spf
delay-time
hold-time
Specify the SPF delay and hold time.
•
delay-time
— SPF delay time. (Range: 0–65535 seconds)
•
hold-time
— SPF hold time. (Range: 0–65535 seconds)
exit Exit to Global Configuration mode.
exit Exit to Privileged EXEC mode.
show ip ospf View OSPF global configuration and status.
show ip ospf statistics View OSPF routing table calculation statistics.
clear ip ospf
[{
configuration
|
redistribution
|
counters
|
neighbor
[
interface
vlan
vlan-id
[
neighbor-id
]]}]
Reset specific OSPF states. If no parameters are specified,
OSPF is disabled and then re-enabled.
Command Purpose
configure Enter global configuration mode.
interface vlan
vlan-id
Enter Interface Configuration mode for the specified
VLAN.
Command Purpose

Table of Contents

Other manuals for Dell PowerConnect 7024

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 7024 and is the answer not in the manual?

Dell PowerConnect 7024 Specifications

General IconGeneral
BrandDell
ModelPowerConnect 7024
CategorySwitch
LanguageEnglish

Related product manuals