Dell PowerConnect W AirWave 7.1 | User Guide Configuring and Using Device Groups in AWMS | 91
Configuring Group Security Settings
The Groups > Security page allows you to set security policies for APs in a device group. Perform these steps.
1. Select the device group for which to def
ine security settings from the Groups > List page.
2. Select the Groups > Security page. Some
controls on this page interact with additional AWMS pages. Figure
43 illustrates this page and Table 53 explains the fields and default values.
Figure 43 Group
s > Security Page Illustration
Table 53 Group
s > Security Page Fields and Default Values
Setting Default Description
VLANs Section
VLAN Tagging and Multiple
SS
IDs
Enabled This field enables support for VLANs and multiple SSIDs on the wireless network. If
this setting is enabled, define additional VLANs and SSIDs on the Groups > SSIDs
page. Refer to “Configuring Group SSIDs and VLANs” on page94.
Management VLAN ID Untagged This setting sets the ID for the manageme
nt VLAN when VLANs are enabled in
AWMS. This setting is supported only for the following devices:
Proxim AP-600, AP-700, AP-2000, AP-4000
Avaya AP-3, Avaya AP-7, AP-4/5/6, AP-8
ProCurve520WL; ProCurve420
Enterasys AP3000