Steps
1. Align and insert the witness sled into chassis.
2. Using the witness sled handle, slide the sled until it locks into place.
NOTE: The XR4000w (witness) sled in not hot pluggable and it is recommended to power off the chassis before
installing the witness sled. Once power is re-applied to the chassis, the Witness sled must be allowed time to boot. This
boot time should be around 5 minutes.
Figure 38. Installing the witness sled into XR4000r
Figure 39. Installing the witness sled into XR4000z
Installing and removing system components
47
To Next Page
Loading...
