Figure 45. Installing the system battery
System board
This is a service technician replaceable part only.
Removing the system board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the following components:
a. Witness sled
b. M.2 module
Steps
1. Using a Phillips 2 screwdriver, remove the screws that secure the witness sled system board to the system.
2. Hold the witness sled system board by the edges and slide it towards the rear. Lift the system board out of the system.
Installing and removing system components
53
To Next Page
Loading...
