Chapter 3. Supported SCSI Commands
The media changer SCSI command set supports the following commands:
Command Operation Code Standard Support Status
INITIALIZE ELEMENT STATUS 07h SMC-2 supported
INITIALIZE ELEMENT STATUS WITH RANGE 37h SMC-2 supported
INQUIRY 12h SPC-3 supported
LOG SELECT 4Ch SPC-3 supported
LOG SENSE 4Dh SPC-3 supported
MODE SELECT (6) 15h SPC-3 supported
MODE SENSE (6) 1Ah SPC-3 supported
MODE SELECT (10) 55h SPC-3 supported
MODE SENSE (10) 5Ah SPC-3 supported
MOVE MEDIUM A5h SMC-2 supported
OPEN/CLOSE IMPORT/EXPORT ELEMENT 1Bh SMC-3 supported
PERSISTENT RESERVE IN 5Eh SPC-3 supported
PERSISTENT RESERVE OUT 5Fh SPC-3 supported
POSITION TO ELEMENT 2Bh SMC-2 supported
PREVENT/ALLOW MEDIUM REMOVAL 1Eh SPC-3 supported
READ BUFFER 3Ch SPC-3 supported
READ ELEMENT STATUS B8h SMC-2 supported
RECEIVE DIAGNOSTIC RESULTS 1Ch SPC-3 not supported
RELEASE (6) 17h SPC-3 supported
RELEASE (10) 57h SPC-3 supported
REPORT SUPPORTED OPERATION CODES A3h SPC-3 supported
REPORT TIMESTAMP A3h SPC-3 supported
REQUEST SENSE 03h SPC-3 supported
REQUEST VOLUME ELEMENT ADDRESS B5h SMC-2 supported
RESERVE (6) 16h SPC-3 supported
RESERVE (10) 56h SPC-3 supported
SET TIMESTAMP A4h SPC-3 supported
SEND DIAGNOSTIC 1Dh SPC-3 supported
SEND VOLUME TAG B6h SMC-2 supported
TEST UNIT READY 00h SPC-3 supported
WRITE BUFFER 3Bh SPC-3 supported
3-1
To Next Page
Loading...
