SDCI 0100h
Serial Monitor 0200h
TNT Monitor 0400h
Debug Monitor 0800h
Test 1000h
MN Server 2000h
Network 4000h
RMU 8000h
Next table describes the possible Data types of event data.
Data type of event data Identifier
Binary 00h
ASCII 01h
Tape Alert Log Page (2Eh)
This page consists of the Page Header followed by 64 Tape Alert flags. Each Tape Alert flag stands for a
pre-determined media changer specific error condition. Tape Alert Flags range from 1 until 64. Every tag
number has a standardized meaning. This page will not be affected by the LOG SELECT command. This
page can be retrieved by means of a Log Sense command with PC (Page Control) set either to 00b or
01b.
Bit 7 6 5 4 3 2 1 0
Byte
0 Reserved Page Code (2Eh)
1 Reserved
2 (MSB) Page Length (0140h)
3 (LSB)
4 -
323
64 Tape Alert Flag structures (320 bytes)
The media changer will support the following Tape Alert Flags:
Parameter
Code
Flag name Type Description
01d Library
Hardware A
C The media changer mechanism is having difficulty communicating with the
drive:
v Turn the library OFF then ON
v Restart the operation
If
problem persists, contact Technical Support.
02d Library
Hardware B
W There is a problem with the media changer mechanism. If the problem
persists, contact Technical Support.
03d Library
Hardware C
C The media changer has a hardware fault:
v Make sure the media changer and drives are not being used by any
host, then reset the library from the front panel.
v If the problem persists, contact Technical Support.
Chapter 3. Supported SCSI Commands 3-15
To Next Page
Loading...
Need help?
General
