Parameter
Parameter Description
controller
RAID controller module that you want to revive.
Valid RAID controller module identifier values are 0
and 1. The identifier value is 0 for the RAID
controller module on the top and
1 for the RAID
controller module on the bottom when viewed
from the rear of the enclosure. You must put
brackets ([ ]) around the RAID controller module
identifier. If you do not specify a RAID controller
module, the storage management software returns
a syntax error.
Enable Storage Array Feature
Description
This command enables a premium feature using a feature key file.
Syntax
enable storageArray [featurePack | feature]
file=”filename”
Parameter
Parameter Description
file
File path and file name of a valid feature key file.
Valid file names for feature key files must end with
a .key extension. You must put quotation marks ("
") around the file path and file name.
Additional Information
A feature pack is a predefined set of premium features, such as Storage Partitioning and Remote
Replication. These premium features are combined for the convenience of the users.
A premium feature is an additional application to enhance the capabilities of a storage array.
NOTE: Before you enable the High Performance Tier premium feature, stop all host I/O operations
to the storage array. When you enable the High Performance Tier premium feature, both RAID
controller modules in the storage array immediately reboot.
223
To Next Page
Loading...
