Dell PowerVault - Stop Storage Array Blink; Stop Storage Array Configuration Database Diagnostic

1489 GB 0 %
1675 GB 0 %
1862 GB 0 %
* = Current SSD cache physical capacity.
Stop Storage Array Blink
Description
This command turns off the indicator lights on the storage array that were turned on by the start
storageArray blink
command.
Syntax
stop storageArray blink
Parameters
None.
Stop Storage Array Configuration Database Diagnostic
Description
This command stops the diagnostic test to validate the configuration database in the RAID controller
module firmware that was started by the start storageArray configDbDiagnostic command.
Syntax
stop storageArray configDbDiagnostic
Parameters
None.
Notes
The controller firmware returns a confirmation that the diagnostic test was cancelled.
In addition, you can start the database configuration diagnostic test through the storage management
software GUI; however, you cannot stop the database configuration diagnostic test through the storage
management software GUI. If you want to stop a running diagnostic test, you must use the stop
storageArray configDbDiagnostic command.
If you try to use the stop storageArray configDbDiagnostic command after validation of the
storage array configuration is complete, you do not receive any message that the validation has finished.
This behavior is expected.
381