Dell PowerVault - Show Virtual Disk Action Progress; Show Virtual Disk Copy

Notes
For snapshot virtual disk copies, the show virtualDisk command returns information about the
schedules for the snapshot virtual disk copies. The schedule information is in this form:
Schedule State: "Active" | "Disabled" | "Completed"
Last Run Time: <mm/dd/yyyy> <hh:mm a.m. | p.m.>
Next Run Time: <mm/dd/yyyy> <hh:mm a.m. | p.m.>
Start Date: <mm/dd/yyyy> End Date: <mm/dd/yyyy> | "No End Date"
End Date:
Days of Week: <Sunday - Saturday>, <Sunday - Saturday>, ….
Times for snapshot recreate: <hh:mm a.m. | p.m.>, <hh:mm a.m. | p.m.>
Show Virtual Disk Action Progress
Description
For a long-running operation that is currently running on a virtual disk, this command returns information
about the virtual disk action and amount of the long-running operation completed. The completed
amount of the long-running operation is shown as a percentage (for example, 25 means that 25 percent
of the long-running operation is completed).
Syntax
show virtualDisk ["virtualDiskName"] actionProgress
Parameters
Parameter Description
virtualDisk
Name of the virtual disk running the long‑running
operation. You must put quotation marks (" ") and
brackets ([ ]) around the virtual disk name.
The virtual disk name and quotation marks must be
inside the brackets.
Show Virtual Disk Copy
Description
This command returns information about virtual disk copy operations. The following information is
returned:
• Copy status
• Start timestamp
• Completion timestamp
• Copy priority
• Source virtual disk WWID or target virtual disk WWID
• Read-only attribute setting of the target virtual disk
You can retrieve information about a specific virtual disk copy pair or all virtual disk copy pairs in the
storage array.
351