Dell PowerVault - Stop Consistency Group Snapshot Rollback

Stop Consistency Group Snapshot Rollback
Description
This command stops a rollback operation to the member base virtual disks in a snapshot consistency
group that was initiated by the start rollback cgSnap command.
NOTE: Canceling a consistency group snapshot rollback operation leaves the base virtual disk in an
indeterminate state with potentially invalid or inconsistent data. The related consistency group
snapshot virtual disk becomes disabled and unusable.
Syntax
stop cgSnapImage["consistencyGroupName"]| rollback
[memberVirtualDiskSet ["memberVirtualDiskName1 ... memberVirtualDiskNamen"]]
Parameters
Parameter Description
consistencyGroupName
The name of the consistency group for which you
want to stop a rollback operation. Enclose the
name of the consistency group in double
quotation marks (" ") inside square brackets ([ ]).
When the memberVirtualDiskSet parameter is
not used, the rollback process applies to all
member virtual disks of the consistency group.
memberVirtualDiskSet
The name of one or more member base virtual
disks in a consistency group that you want to stop
a rollback operation. Enclose each member base
virtual disk name in double quotation marks (" ")
inside parenthesizes (( )).
You can enter more than one member virtual disk
name. Enclose all of the member virtual disk
names in one set of double quotation marks (" ")
inside parenthesizes (( )). Separate each member
virtual disk name with a white space.
Notes
To stop a roll back operation for an entire consistency group that has the name congroup1, you would
use this command:
stop cgSnapImage ["congroup1"] rollback;
To start a roll back operation for base virtual disk members memVol1, memVol2, and memVol3 in a
consistency group that has the name congroup2, you would use this command:
stop cgSnapImage ["congroup2"] rollback memberVirtualDiskset=("memVol1 memVol2
memVol3");
370