Dell PowerVault - CLI Command Updates; New Commands

13
CLI Command Updates
This chapter reflects new and updated commands that are available for use with Dell's PowerVault
Modular Disk Series of storage arrays.
NOTE: Not all commands are necessarily valid with all storage arrays - some commands are specific
to certain platforms.
CAUTION: Script commands are capable of changing the configuration and may cause loss of
data if not used correctly. Command operations are performed as soon as you run the
commands. Before using the script commands, ensure that you have backed up all data, and have
saved the current configuration so that you can reinstall it if the changes do not work.
New Commands
The following commands have been added to this guide to reflect the additional functionality available in
the PowerVault MD32xx and MD36xx series of storage arrays.
• Add Member To Consistency Group
• Add Physical Disks to SSD Cache
• Add Virtual Disk to Remote Replication Group
• Blink SSD Cache
• Cancel Remote Replication Group Role Reversal
• Change SSD Cache Application Type
• Check Remote Replication Group Consistency
• Check Repository Consistency
• Check Storage Array Connectivity
• Clear Remote Replication Fault
• Convert A Snapshot (Legacy) Virtual Disk To A Snapshot Group
• Create Consistency Group
• Create Consistency Group Snapshot Image
• Create Consistency Group Snapshot Virtual Disk
• Create Consistency Group Snapshot Virtual Disk Mapping
• Create Read-Only Snapshot Virtual Disk
• Create Remote Replication Group
• Create Snapshot (Legacy) Virtual Disk
• Create Snapshot Group
• Create Snapshot Image
• Create SSD Cache
• Deactivate Remote Replication
• Delete Consistency Group
• Delete Consistency Group Snapshot Image
393