Dell PowerVault - Show Physical Disk Download Progress; Show RAID Controller Module

Show Physical Disk Download Progress
Description
This command returns the status of firmware downloads for the physical disks targeted by the download
physicalDisk firmware or download storageArray physicalDiskFirmware commands.
Syntax
show allPhysicalDisks downloadProgress
Parameters
None.
NOTE: When all firmware downloads have successfully completed, this command returns a
Successful status. If any firmware downloads fail, this command shows the firmware download
status of each targeted physical disk. This command returns the status values shown in the
following table.
Status Definition
Successful Downloads completed without errors.
Not Attempted Downloads did not start.
Partial Download Downloads are in progress.
Failed Downloads completed with errors.
Show RAID Controller Module
Description
For each RAID controller module in a storage array, this command returns the following information:
• Status (Online, Offline)
• Current firmware and NVSRAM configuration
• Pending firmware and NVSRAM configuration configurations (if any)
• Board ID
• Product ID
• Product revision
• Serial number
• Date of manufacture
• Date and time to which the RAID controller module is set
• Associated virtual disks (including preferred owner)
• Ethernet port
• Physical disk interface
329