Dell PowerVault - Set Disk Pool

Syntax
set diskGroup [diskGroupName] forcedState
Parameters
Parameter Description
diskGroup
Sequence number of the disk group for which to
set properties. You must put brackets ([ ]) around
the disk group number.
NOTE: You can move the physical disks that comprise a disk group from one storage array to
another storage array. The CLI provides three commands that let you move the physical disks. The
commands are start diskGroup export, start diskGroup import, and set diskGroup
forcedState
. In the Forced state, you can perform an import operation on the disk group.
Set Disk Pool
Description
This command sets the attributes associated with a disk pool based on the specified parameters.
Syntax
set diskPool
(diskPool=[diskPoolName] | diskPools=[diskPoolName1... diskPoolNamen] |
allDiskPools)
[reservePhysicalDiskCount=reservePhysicalDiskCountValue |
warningThreshold=(warningThresholdValue | default) |
criticalThreshold=(criticalThresholdValue | default) |
criticalPriority=(highest|high|medium|low|lowest) |
backgroundPriority=(highest|high|medium|low|lowest) |
degradedPriority=(highest|high|medium|low|lowest)
userLabel=
diskPoolName]
Parameters
Parameter Description
diskPools
The list of diskPoolNames identifies multiple
physical disk pool which have their parameters
reset by the command.
allDiskPools
This parameter specifies that all physical disk pools
have their parameters reset by the command.
reservePhysicalDiskCount
This value is specified in terms of the number of
physical disks to reserve in the disk pool for
physical disk failures or physical disk removals.
warningThreshold
The percentage of disk pool capacity at which you
receive a warning alert that the disk pool is nearing
273