Dell PowerVault - Start Remote Replication (Legacy) Synchronization; Start Secure Physical Disk Erase

Start Remote Replication (Legacy) Synchronization
Description
NOTE: This command valid only with Fibre Channel storage arrays.
This command starts Remote Replication (legacy) synchronization.
Syntax
start remoteReplication primary
[”virtualDiskName”] synchronize
Parameters
Parameter Description
primary
The name of the primary virtual disk for which you
want to start synchronization. Enclose the primary
virtual disk name in double quotation marks (“ ”)
inside square brackets ([ ]).
Start Secure Physical Disk Erase
Description
This command erases all of the data from one or more self-encrypting disk (SED) physical disks so that
they can be reused as SED physical disks. Run this command only when the SED physical disks are no
longer part of a secure disk group, or when the security key is unknown.
NOTE: When performing a secure erase operation on all physical disks in an array that contains only
SED physical disk type, the physical disks must be erased in two groups using the start
secureErase physicalDisks[] command. For example, if there are seven (7) SED physical
disks, the secure erase can be performed by executing:
start secureErase physicalDisks [0,0 0,1 0,2 0,3];
start secureErase physicalDisks [0,4 0,5 0,6];
Syntax
start secureErase (physicalDisk [enclosureID,slotID] |
physicalDisks [enclosureID1,slotID1 enclosureID2, slotID2...
enclosureIDn,slotIDn])
Parameters
Parameter Description
physicalDisk or physicalDisks
Identifies the enclosure and slot where the physical
disk resides. Enclosure ID values are 0 to 99. Slot
ID values are 0 to 31. You must put brackets ([ ])
around the enclosure ID value and slot ID value.
363