Dell PowerVault - Set Disk Group

Parameters
Parameter Description
cgSnapVirtualDisk
The name of the consistency group virtual disk that
you want to rename. Enclose the name of the
consistency group snapshot virtual disk in square
brackets ([ ]).
userLabel
The new name that you want to give to the
snapshot virtual disk in the consistency group.
Enclose the new snapshot virtual disk name in
double quotation marks (" ").
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.
Set Disk Group
Description
This command defines the properties for a disk group.
Syntax
set diskGroup [diskGroupName]
addPhysicalDisks=(enclosureID1,slotID1 enclosureID2,slotID2...
enclosureIDn,slotIDn)
raidLevel=(0 | 1 | 5 | 6)
owner=(0 | 1)
Parameters
Parameter Description
diskGroup
Sequence number of the disk group for which to
set properties. You must put brackets ([ ]) around
the disk group number.
addPhysicalDisks
Identifies the physical disk by enclosure and slot
location to include in the disk group. Enclosure ID
values are 0 to 99. Slot ID values are 0 to 31.
You must put parentheses around the enclosure ID
values and the slot ID values.
raidLevel
The RAID level for the disk group. Valid values are
0, 1, 5, or 6.
owner
The RAID controller module that owns the disk
group. Valid RAID controller module identifier
271