EasyManua.ls Logo

Dell PowerVault - Page 287

Dell PowerVault
396 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parameters
Parameter Description
localVirtualDisk The name of the local virtual disk for which you
want to define properties. Enclose the primary
virtual disk name in square brackets ([ ]). If the
primary virtual disk name has special characters or
numbers, you must enclose the primary virtual disk
name in double quotation marks (" ") inside square
brackets.
localVirtualDisks The names of several local virtual disks for which
you want to define properties. Enter the names of
the virtual disks using these rules:
Enclose all of the names in square brackets ([ ]).
Separate each of the names with a space.
If the virtual disk names have special characters or
consist only of numbers, enter the names using
these rules:
Enclose all of the names in square brackets ([ ]).
Enclose each of the names in double quotation
marks (" ").
Separate each of the names with a space.
role The setting for the local virtual disk to act as the
primary virtual disk or the secondary virtual disk. To
define the virtual disk as the primary virtual disk, set
this parameter to primary. To define the virtual
disk as the secondary virtual disk, set this
parameter to secondary. This parameter applies
only when the virtual disk is part of a replication
relationship.
syncPriority The priority that full synchronization has relative to
host I/O activity. Valid values are highest, high,
medium, low, or lowest.
autoResync The settings for automatic resynchronization
between the primary virtual disks and the
secondary virtual disks of a remote-replicated pair.
This parameter has these values:
enabled – Automatic resynchronization is
turned on. You do not need to do anything
further to
resynchronize the primary virtual
disk and the secondary virtual disk.
disabled – Automatic resynchronization
is turned off. To resynchronize the primary
virtual disks and the secondary virtual disk, you
must run the resume remoteReplication
command.
writeOrder This parameter defines write order for data
transmission between the primary virtual disk and
287

Table of Contents

Other manuals for Dell PowerVault

Related product manuals