Dell PowerVault - Page 367

[diagnosticType = (fileSystem | mirror | contentCheck)]
[controller[(0 | 1)]]
Parameters
Parameter Description
sourceLocation
This parameter specifies the location of the
database.
• disk indicates that data comes directly from
the database on the physical disk.
• onboard indicates that data comes from the
RPA memory location
The default location is disk.
diagnosticType
The level of diagnostic testing that you want to run
on the database. You can run one of these levels of
testing:
fileSystem
This option checks the
structural integrity of the
database.
mirror
• When the
sourceLocation
parameter is set to disk,
the peer RAID controller
module initiates a block
check.
• When the
sourceLocation
parameter is set to
cache, the peer RAID
controller module
initiates a record check.
contentCheck
This option performs a deep
analysis of each record's
contents.
The default value is fileSystem.
controller
The RAID controller module that has the database
on which you want to run the diagnostic tests.
Valid RAID controller module identifiers are 0 or 1,
where 0 is the RAID controller module in slot 0,
and
1 is the RAID controller module in slot 1.
Enclose the RAID controller module identifier in
square brackets ([ ]).
367