Installing the GPU card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the GPU card and provides a visual representation of the installation procedure.
Images to be uploaded in the next review cycle
Steps
1. Align and place the GPU card into its slot on the plamrest.
2. Replace the three (M2x5) screws to secure the GPU card to the palmrest.
Next steps
1. Install the system board.
2. Install the inner frame.
3. Install the heat-sink assembly.
4. Install the primary memory.
5. Install the GPU power cable.
6. Install the keyboard.
7. Install the keyboard lattice.
8. Install the WLAN card.
9. Install the WWAN card.
10. Install the secondary memory.
11. Install the SIM card.
12. Install the primary M.2 SSD.
13. Install the battery.
14. Install the base cover.
15. Install the secondary M.2 SSD.
16. Install the SSD door.
17. Install the SD card.
18. Follow the procedure in after working inside your computer.
Speaker
Removing the speaker
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the SSD door.
4. Remove the secondary M.2 SSD.
5. Remove the base cover.
6. Remove the battery.
7. Remove the primary M.2 SSD.
8. Remove the SIM card.
9. Remove the secondary memory.
10. Remove the WWAN card.
11. Remove the WLAN card.
12. Remove the keyboard lattice.
13. Remove the keyboard.
68
Disassembly and reassembly
To Next Page
Loading...
