Dell S4128F-ON Series User Manual

Specications
This section lists the S4100–ON Series (S4128F-ON and S4148F-ON) switch specications.
CAUTION: Operate the product at an ambient temperature not higher than 113°F—45°C.
CAUTION: Lithium Battery Caution: There is a danger of explosion if the battery is incorrectly replaced. Replace only with same
or equivalent type of battery. Dispose of the batteries according to the manufacturer's instructions.
Topics:
• Chassis physical design
• IEEE standards
• Agency compliance
• USA Federal Communications Commission (FCC) statement
• European Union EMC directive conformance statement
• Japan: VCCI compliance for class A equipment
• Korean certication of compliance
• Safety standards and compliance agency certications
• Electromagnetic compatibility (EMC)
• Product recycling and disposal
Chassis physical design
Table 13. Chassis physical design
Parameter Specications
Height 1.71 inches (43.5 mm)
Width 17.1 inches (434 mm)
Depth
18.1 inches (460 mm)
Handle: 0.82 inch (21 mm)
Chassis weight with factory-installed components
S4128F-ON: 19.66 lbs/8.92 kg (2* PSUs)
S4148F-ON: 20.15 lbs/9.14 kg (2* PSUs)
Rack clearance required
Front: 5 inches (12.7 cm)
Back: 5 inches (12.7 cm)
8
40 Specications

Dell S4128F-ON Series Specifications

General

Rack Units	1U
Airflow	Front-to-back or back-to-front
Manageable	Yes
Jumbo Frame Support	Yes
Jumbo Frame Size	9216 bytes
Model	S4128F-ON
Switch Type	Layer 3
Form Factor	Rack-mountable
Ports	28 x 10GbE SFP+
Power Supply	2
Product Type	Ethernet Switch
MAC Address Table Size	128000
Input Voltage	100 V AC to 240 V AC
Power Consumption Operational	200 W
Product Series	S-Series
Forwarding Capacity	1.072 Bpps
Operating System	Open Networking (ON)