Dell SonicWALL Secure Mobile Access 8.5
Administration Guide
198
4 Select a Scheme to connect to the backend server. Select one of the following options from the drop-
down list: HTTP, HTTPS, or AUTO. The default value is HTTPS.
If AUTO is selected, specify two port numbers for HTTPS and HTTP.
5 Enter the back end HTTP(S) server IP address in the IPv4/IPv6 Address field.
6 Enter the Port for the backend server. The default value for an HTTPS connection is 443. For Auto
schemes, enter the port numbers for HTTPS and HTTP.
7Click Accept to add this member to the group.
Portals > URL Based Aliasing
This section provides an overview of the Portals > URL Based Aliasing page and a description of the
configuration tasks available on this page.
• URL Based Aliasing overview on page 198
• Adding a URL Based Aliasing group on page 198
• Default Site Settings on page 201
• URL Based Aliasing Group with Application Offloading on page 202
URL Based Aliasing overview
URL Based Aliasing provides the ability to access several different Web sites through one portal using one
domain name. This feature is designed to be consistent with the Load Balancing setting. Because URL Based
Aliasing involves rewriting URLS found in the content served by the backend Web server, the backend Web
application should be compatible with third-party proxies. If a Web application does not render properly using
URL Based Aliasing, you might need to set up access to the application using App Offloading without URL
rewriting or using NetExtender.
Adding a URL Based Aliasing group
See also:
• Adding members on page 200
• Deleting a group on page 200
• Deleting a member on page 201
NOTE: To enable HTTP access for the App Offloading Portal, select Enable HTTP access, located
on the Virtual Host tab of the portal.
To Next Page
Loading...
