Dell SonicWALL Secure Mobile Access 8.5
Administration Guide
279
Configuring Web Application Firewall Settings
The Web Application Firewall > Settings page allows you to enable and disable Web Application Firewall on
your SMA/SRA appliance globally and by attack priority. You can individually specify detection or prevention for
three attack classes: high, medium, and low priority attacks.
This page also provides configuration options for other Web Application Firewall settings. The following sections
describe the procedures for enabling and configuring Web Application Firewall settings:
• Enabling Web Application Firewall and Configuring General Settings on page 279
• Configuring Global Exclusions on page 280
• Configuring Intrusion Prevention Error Page Settings on page 281
• Configuring Cross-Site Request Forgery Protection Settings on page 282
• Configuring Cookie Tampering Protection Settings on page 283
• Configuring Web Site Cloaking on page 284
• Configuring Information Disclosure Protection on page 285
• Configuring Session Management Settings on page 286
Enabling Web Application Firewall and Configuring General
Settings
To enable and activate Web Application Firewall, you must select the check box to globally enable it and select
at least one of the check boxes in the Signature Groups table. The settings in the General Settings section on
this page allow you to globally manage your network protection against attacks by selecting the level of
protection for high, medium, or low priority attacks. You can also clear Global Enable Web Application
To Next Page
Loading...
