Steps
1. Place the heat sink on the system board.
2. Tighten the seven (M2x3) captive screws that secure the heat sink to the system board.
NOTE: Tighten the captive screws in the sequential order mentioned on the heat sink [7>6>5>4>3>2>1].
NOTE: The number of screws varies depending on the configuration ordered.
Next steps
1. Install the base cover.
2. Install the SD card.
3. Follow the procedure in After working inside your computer.
I/O daughter board FFC
Removing the Input/Output daughter board FFC
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the fan.
About this task
The following image indicates the location of the Input/Output daughter board FFC and provides a visual representation of the
removal procedure.
36
Removing and installing components
To Next Page
Loading...
