Steps
1. Place the I/O daughter board FFC on the palm-rest and keyboard assembly.
2. Connect the I/O daughter board FFC the connector on the I/O board.
3. Connect the I/O daughter board FFC the connector on the system board.
Next steps
1. Install the fan.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in After working inside your computer.
I/O board
Removing the Input/Output board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the fan.
5. Remove the SSD.
About this task
The following images indicate the location of the Input/Output board and provide a visual representation of the removal
procedure.
38
Removing and installing components
To Next Page
Loading...
