6. Close the right and align the screw holes on the right hinge with the screw holes on the system board.
7. Replace the two (M2.5x5) screws to secure it to the palm-rest.
Next steps
1. Install the display assembly.
2. Install the heat sink.
3. Install the fan.
4. Install the wireless card.
5. Install the SSD.
6. Install the memory modules.
7. Install the battery.
8. Install the base cover.
9. Install the SD card.
10. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palmrest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery .
5. Remove the memory modules.
6. Remove the SSD.
7. Remove the wireless card.
8. Remove the fan.
9. Remove the heat sink.
10. Remove the I/O board FFC.
11. Remove the I/O board.
12. Remove the speakers.
13. Remove the touchpad.
14. Remove the display assembly.
15. Remove the power-adapter port.
16. Remove the power button.
17. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The following image indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the
removal procedure.
84
Removing and installing components
To Next Page
Loading...
