Camera assembly
Removing the camera module (Plastic)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the display hinge caps.
7. Remove the display bezel.
8. Remove the display hinges.
9. Remove the display panel.
10. Remove the eDP cable.
About this task
The following images indicate the location of the camera module (in a system shipped with plastic chassis) and provide a visual
representation of the removal procedure.
Steps
1. Using the pull tab, disconnect the camera cable from the camera module.
2. Using a plastic scribe, pry the camera module from the display assembly.
NOTE: Start prying the camera module in a sequential order 1>2>3 as indicated on the display back cover.
3. Lift the camera module from the display assembly.
Installing the camera module (Plastic)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
70
Removing and installing components
To Next Page
Loading...
