Steps
1. Place the display panel and display assembly on a clean and flat surface.
2. Connect the display cable to the connector on the display panel and close the latch.
3. Adhere the tape to secure the display-cable connector latch to the display panel.
4. Lift and rotate the display panel, and then place the display panel on the display assembly.
5. Place the display bezel on the display assembly.
6. Align the tabs on the display bezel to the slots on the display assembly.
7. Press down on the display bezel and snap the display bezel in place.
8. Replace the two (M2x2) screws to secure the display panel to the back cover.
Next steps
1. Install the hinges.
2. Install the display bezel.
3. Install the hinge caps.
4. Install the display assembly.
5. Install the wireless card.
6. Install the SSD.
7. Install the base cover.
8. Install the SD card.
9. Follow the procedure in After working inside your computer.
eDP cable
Removing the eDP cable (Plastic)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the memory modules.
5. Remove the SSD.
6. Remove the wireless card.
7. Remove the display assembly.
8. Remove the hinge caps.
9. Remove the display bezel.
10. Remove the hinges.
11. Remove the display panel.
About this task
The following image indicates the location of the eDP cable (in a system shipped with plastic chassis) and provides a visual
representation of the removal procedure.
Removing and installing components
65
To Next Page
Loading...
