Steps
1. Place the camera module in its slot on the display back cover.
2. Adhere the tape that secures the camera module to the display back cover.
3. Connect the camera cable to the camera module.
Next steps
1. Install the eDP cable.
2. Install the display panel.
3. Install the display hinges.
4. Install the display bezel.
5. Install the display hinge caps.
6. Install the display assembly.
7. Install the wireless card.
8. Install the base cover.
9. Install the SD card.
10. Follow the procedure in After working inside your computer.
Removing and installing components
73
To Next Page
Loading...
