Power-Light Board 15
4
Power-Light Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 9. For additional safety best practices information, see the Regulatory
Compliance Homepage at dell.com/regulatory_compliance.
Prerequisites
1
Remove the base cover. See "Removing the Base Cover" on page 13
Removing the Power-Light Board
1
Lift the connector latch and pull the pull-tab to disconnect the power-
light board cable from the connector on the I/O board.
2
Remove the screw that secures the power-light board to the palm-rest
assembly.
3
Lift the power-light board off the palm-rest assembly.
Spyder_OM_Book.book Page 15 Monday, January 16, 2012 11:02 AM
To Next Page
Loading...
