Wireless Mini-Card 25
CAUTION: When the Mini-Card is not in the computer, store it in protective
antistatic packaging. For more information, see "Protecting Against Electrostatic
Discharge" in the safety information that shipped with your computer.
Replacing the Mini-Card
1
Remove the new Mini-Card from its packaging.
2
Align the notch on the Mini-Card with the tab in the system-board
connector.
CAUTION: Use firm and even pressure to slide the Mini-Card into place. If you
use excessive force, you may damage the connector.
CAUTION: The connectors are keyed to ensure correct insertion. If you feel
resistance, check the connectors on the Mini-Card and on the system board, and
realign the Mini-Card.
CAUTION: To avoid damage to the Mini-Card, never place cables under the
Mini-Card.
1 screw 2 Mini-Card
3 system-board connector
Spyder_OM_Book.book Page 25 Monday, January 16, 2012 11:02 AM
To Next Page
Loading...
