Delta ASDA-M Series - Page 182

ASDA-M Chapter 6 Control Mode of Operation
Revision December, 2014 6-57
MON1 axis
selection
Description
1 MON1 is from X axis
2 MON1 is from Y axis
3 MON1 is from Z axis
MON2 axis
selection
Description
1 MON2 is from X axis
2 MON2 is from Y axis
3 MON2 is from Z axis
NOTE
Please refer to parameter P1-04, P1-05 for proportional setting
of analog output voltage.
For example:
P0-03 = 1101 (MON1 is the analog output of motor speed in X
axis; MON2 is the analog output of motor torque
in X axis.)
MON1outputvoltage  8 

󰇛.


󰇜
(unit: Volts)
MON2output voltage  8 
 
󰇛.  



󰇜
(unit: Volts)
P1-03 AOUT
Polarity Setting of Encoder Pulse
Output
Address: 0106H
0107H
Parameter
Attribute
：
Parameter for individual axis
Related Section:
Section 6.6.3
Operational
Interface
：
Panel / Software Communication
Default：
0
Control
Mode
：
ALL
Unit：
-
Range：
0 ~ 0x13
Data Size：
16bit
Format：
HEX